Hi Alex,
Apologies for the delay in replying to this.
How much traffic is being seen on the machines involved?
Paul
On 02/11/2013 12:05, Alex Page wrote:
Hello, I am seeing strange behavior recently in iftop on Ubuntu (x64, 12.04 and 13.10). With Port Display disabled, iftop simply uses more CPU than normal (say, 20% instead of a negligible amount). Then, when Port Display is enabled, CPU use goes straight to 100% and iftop becomes unresponsive.
This behavior started sometime in the last few months, and occurs on 2 of the 4 Ubuntu machines that I've tested it on. I compiled iftop 0.17 and 1.0-pre2 from source and observed the same behavior as the precompiled version (1.0-pre2 from the Ubuntu repo) on these computers.
I cannot figure out what is unique (other than physical hardware) about the 2 machines that still work, except that they use 3.2 and 3.6 kernels (vs. 3.5 and 3.11 on the machines that don't work). So maybe there's a network driver issue? I checked the version numbers of libc6, libncurses, libpcap, and libtinfo (all the dependencies I know of) and they are the same on 1 of the working machines vs. 1 of the non-working ones. And iftop worked properly on all of these machines until some relatively recent update.
So, iftop is completely unusable on at least 2 of my computers. Can anyone recommend further troubleshooting steps that I could take to isolate this problem, preferably without rebooting? Are there any other library versions I should check?
Thanks, Alex
iftop-users mailing list iftop-users@lists.beasts.org http://lists.beasts.org/mailman/listinfo/iftop-users